气相色谱-串联质谱法测定沉积物中多环芳烃

采用ASE法提取沉积物中16种多环芳烃,以固相萃取法净化提取液,用气相色谱-串联质谱法测定。通过优化测定条件,使方法在5.00μg/L~1 600μg/L范围内线性良好,方法检出限为0.15μg/kg~0.66μg/kg。空白石英砂的加标回收率为61.9%~121%,7次测定结果的RSD为2.6%~11.1%。     

原子吸收法测定土壤中铅的方法

通过湿法消解土壤样品,利用石墨炉原子吸收分光光度法(GAAS)和火焰原子吸收分光光度法(FAAS)测定不同土壤样品中铅的含量,以验证2种方法的有效性并加以对比。实验结果表明:2种方法均满足土壤中铅含量的测定要求,测定的标准土样含量均在标准值的不确定度范围内,GAAS方法测定结果更接近保证值。二者的相对标准偏差(RSD)值均低于1.5%,FAAS方法的精密度更高,且具有快速简单等优势。     

高效液相色谱-三重四级杆/复合线性离子阱质谱法测定饮用水中22种邻苯二甲酸酯

建立了一种同时测定饮用水中22种邻苯二甲酸酯(PAEs)的高效液相色谱-三重四级杆/复合线性离子阱质谱方法:饮用水样品经针头过滤器过滤,选用Biphenyl液相色谱柱进行分离,以含0.1%甲酸的水溶液和含0.1%甲酸的甲醇溶液为流动相,电离模式为电喷雾正离子,选用多反应监测触发增强子离子扫描模式进行检测。结果表明,22种PAEs的灵敏度良好,定量限为0.001～0.1 μg/L。配制浓度为0.1～100.0 μg/L的混标溶液进行进样分析,分析结果显示,22种PAEs在该范围内的线性关系良好,相关系数均大于0.995,方法的平均回收率为82.9%～108.9%,相对标准偏差为0.9%～11.2%。同时,使用增强子离子扫描谱图进行搜库匹配,定性准确性高。该方法适用于饮用水中PAEs的检测。     

An LC-MS/MS method for creatine and creatinine analysis in paraquat-intoxicated patients

Abstract

A sudden increase in serum creatinine after paraquat intoxication has been reported in several clinical studies. However, this dramatic change of creatinine may be possibly due to an interconversion of creatine-creatinine in relation to paraquat toxicity. In order to investigate the creatine-creatinine relationship, a liquid chromatography tandem mass spectrometry in combination with electrospray ionization was developed and validated for simultaneous determination of creatine and creatinine in the serum. The chromatographic separation was achieved on a Gemini® C₆-Phenyl column with a gradient elution consisting of 0.1% formic acid in ultrapure water and methanol as the mobile phase. The method yielded suitable levels of specificity and selectivity, and calibration curves of creatine and creatinine in serum were linear over the concentration range of 0.5–200?µg mL^?1. The limit of quantification of both compounds was 0.5?µg mL^?1, and the method was accurate within the recovery range of 96.23–102.75%, indicating the robustness of the method. The method was successfully applied to toxicological samples from paraquat-intoxicated patients, and the concentrations of creatine and creatinine were quantified. High creatine concentrations in serum samples were observed which may lead to high serum creatinine despite normal kidney function as creatine is converted to creatinine in proportion to its concentration.     

石墨烯薄膜原子氧剥蚀行为及电阻特性

目的研究石墨烯薄膜在原子氧空间环境的适应性,为其在航天器上应用提供参考。方法采用刮涂法制备石墨烯薄膜,将石墨烯薄膜材料及石墨烯电阻传感器置于微波源原子氧设备内开展原子氧试验,原子氧剂量分别为3.0×10^20 atoms/cm2和7.5×10^20 atoms/cm^2,研究薄膜表面形貌、结构、成分及电阻性能的变化。结果采用刮涂法可制备氧含量较低的石墨烯薄膜,原子氧剂量为7.5×10^20 atoms/cm^2情况下,石墨烯薄膜的厚度损失为5.3μm,原子氧反应率为7.14×10^-25 atoms/cm^3。原子氧作用后,石墨烯薄膜中碳原子无序程度增大,C—O、—COOH官能团含量降低,C=O官能团含量增加。石墨烯电阻传感器的R0/R比值随原子氧剂量增加线性降低,0.8μm厚度薄膜可探测最大原子氧剂量为5×10^19 atoms/cm^2,增加薄膜厚度有望提高传感器的使用寿命。结论得到了石墨烯薄膜厚度损失、原子氧反应率、微观结构及电阻特性的变化规律,可为石墨烯薄膜的空间应用提供技术支撑。     

改进测定水中氨氮分子吸收光谱法的试验研究

水中氨氮含量是反应水质状况的重要指标。文章对测定水中氨氮气相分子吸收光谱法(标准号HJ/T195-2005)进行了改进试验研究。第一,对氧化剂的配比进行了改进,使氨氮的测定范围扩展至100μg。第二,对标准HJ/T195-2005中直接使用亚硝酸钠标准溶液做标准曲线的处理方式也做了探讨。通过一系列对比实验认为,应用硫酸铵标准溶液做工作曲线更加准确合理。最后应用改进后的气相分子吸收光谱法和纳氏比色法或滴定法对多种实际废水样品进行同时测定。结果表明,改进后的气相分子吸收光谱法测定氨氮的范围更宽,灵敏度更高和准确度更好。     

重金属离子与依诺沙星相互作用的荧光光谱法研究

荧光分析法是利用物质的荧光性质对物质进行分析的方法,文章应用荧光法研究了不同温度下重金属离子Cu2+、Pb2+及Mn2+与喹诺酮类药物依诺沙星(ENX)的相互作用。结果表明:Cu2+、Pb2+及Mn2+对ENX内源荧光的猝灭机制属于形成复合物所引起的静态猝灭,利用Stern-Volmer关系式计算了ENX与重金属离子Cu2+、Pb2+及Mn2+之间的猝灭常数KSV及结合位点数,根据热力学参数(自由能变ΔG、焓变ΔH、熵变ΔS)确定了ENX与重金属离子之间的主要作用力类型为静电作用力。该研究为探讨环境中重金属离子与ENX的作用机理和环境效应提供了理论依据。     

Biological sulfate removal from acrylic fiber manufacturing wastewater using a two-stage UASB reactor

A two-stage UASB reactor was employed to remove sulfate from acrylic fiber manufacturing wastewater. Mesophilic operation (35±0.5℃) was performed with hydraulic retention time (HRT) varied between 28 and 40 hr. Mixed liquor suspended solids (MLSS) in the reactor was maintained about 8000 mg/L. The results indicated that sulfate removal was enhanced with increasing the ratio of COD/SO₄^2-. At low COD/SO₄^2-, the growth of the sulfate-reducing bacteria (SRB) was carbon-limited. The optimal sulfate removal efficiencies were 75% when the HRT was no less than 38 hr. Sulfidogenesis mainly happened in the sulfate-reducing stage, while methanogenesis in the methane-producing stage. Microbes in sulfate-reducing stage performed granulation better than that in methane-producing stage. Higher extracellular polymeric substances (EPS) content in sulfate-reducing stage helped to adhere and connect the flocculent sludge particles together. SRB accounted for about 31% both in sulfate-reducing stage and methane-producing stage at COD/SO₄^2- ratio of 0.5, while it dropped dramatically from 34% in sulfate-reducing stage to 10% in methane-producing stage corresponding to the COD/SO₄^2- ratio of 4.7. SRB and MPA were predominant in sulfate-reducing stage and methane-producing stage respectively.     

Determination of ammonium on an integrated microchip with LED-induced fluorescence detection

A simply fabricated microfluidic device integrated with a fluorescence detection system has been developed for on-line determination of ammonium in aqueous samples. A 365-nm light-emitting diode (LED) as an excitation source and a minor band pass filter were mounted into a polydimethylsiloxane (PDMS)-based microchip for the purpose of miniaturization of the entire analytical system. The ammonium sample reacted with o-phthaldialdehyde (OPA) on-chip with sodium sulfite as reducing reagent to produce a fluorescent isoindole derivative, which can emit fluorescence signal at about 425 nm when excited at 365 nm. Effects of pH, flow rate of solutions, concentrations of OPA-reagent, phosphate and sulfite salt were investigated. The calibration curve of ammonium in the range of 0.018-1.8 μupg/mL showed a good linear relationship with R² = 0.9985, and the detection limit was (S/N = 3) 3.6 × 10^-4 μupg/mL. The relative standard deviation was 2.8% (n = 11) by calculating at 0.18 μupg/mL ammonium for repeated detection. The system was applied to determine the ammonium concentration in rain and river waters, even extent to other analytes fluorescence detection by the presented device.     

原子荧光光谱仪测定底泥中砷含量的不确定度评定

介绍了原子荧光光谱仪测定底泥中砷含量的不确定度评定方法,分析和识别测量过程中不确定度的来源,较为全面地评定了测量不确定度。根据最小二乘法拟合计算工作曲线的标准不确定度,采用极差法评定测量次数较少时引起的标准不确定度。